Configure the Core lap counter

Before you can use the Core lap counter you must configure the serial device. This is done by going to the Config. page of the software. Toward the bottom of this page you need to select which COM device that the Core lap counter is on and click the save connection button.

Windows Specific: Most likely in Windows the COM device will be the last in the list.

Mac Specific: Most likely the device will start with usb- followed by a series of numbers

Add new racers

After you have configured your hardware you are now ready to add new racers. When the racer is in the middle of the antenna you can click the create new racer button to create a new blank racer. Then click the scan button to read the RFID tag. After you have set the name and other settings to what you want click the save button. You are now ready to add another racer.

Selecting racers for a race

If you line up all the racers for a race within the antenna and click the scan button they will be automatically added. Or if you click the add button next to the slots. A window will pop up allow you to select which racers you want to participate in the race. This window allows multi-selection. Up to 8 racers can be added to a race at any time. Racers can only be removed if a race has not started.