| 56 | After you have built your connector there are 1 or 2 diodes that need soldered to bridge the transmit (orange) and receive (yellow) wires. When soldering the diodes in place make sure the black line is facing the yellow (receive) wire. If the diodes are installed backwards your adapter will not work. |
| 57 | |
| 58 | Once the diodes are installed you must make an additional connection between the yellow (receive) wire and pin 2 of the JST ZH connector. This is the signal pin. Out of the 4 pins in the connector only the signal and ground pins must be connected. |
| 59 | |
| 60 | Finally to connect the ground lines you must connect the black (ground) wire from the USB to TTL adapter to pin 4 of the JST ZH connector. |
| 61 | |
| 62 | You should now have your own USB to ICS adapter, congratulations. |